A step-for-step video instruction for building the biotic gaming device (a compilation video with all steps can be found at the bottom)

A little change: the 50 mm bolts used at step 8 to assemble the stack of spaceships are now replaced by 95 mm wires. You need to screw on extra nuts at the bottom of each wire.

Step 1 - Disassemble webcam

Step 2 - Reverse the lens

Step 3 - Put screws into base plate, insert webcam holder

Step 4 - Attach double-sided tape for webcam

Step 5 - Insert webcam

Step 6 - Sandwich webcam between plates and tighten with nuts

Step 7 - Turn three nuts and insert plate

Step 8 - Assemble stack of three spaceships

Step 9 - Insert four 3MM LEDs under an angle

Step 10 - Put on the top spaceship

Step 11 - Tighten the spaceship stack with three nuts

Step 12 - Put stack of spaceships on bottom part

Step 13 - Screw on three nuts to hold top LED holder

Step 14 - Plug in 5 MM LED on top

Step 15 - Microscope slide: peel off cover foil

Step 16 - Microscope slide: peel off small cover foil

Step 17 - Microscope slide: peel off double-sided tape, stick parts together

Step 18 - Microscope slide: pipette Euglena

All Steps